NathanTools
NathanTools
Text Tools 13
SEO Tools 7
Image Tools 19
YouTube Tools 38
Device Tests 4
PDF Tools 10
Calculators 52
Electrical Calculators 10
Time Tools 7
Random Tools 9
Converters 14
Developer Tools 11
Hash Generators 5
Password & Security 2
Network & DNS 3
Website Tools 9

Voltage Divider Calculator

Enter the input voltage and resistors to get Vout, or choose a target voltage to find the resistor values.

100% free No sign-up Works on any device

Type resistor values like 4700, 4.7k, 4k7 or 1M.

VinR1R2Vout0 V

–

–

–Current
–Power in R1
–Power in R2
–Vout with load

Updated November 2026 · Calculated in your browser

How to use the voltage divider calculator

  1. On Find Vout, enter the input voltage and both resistors.
  2. On Find R1 or Find R2, enter the target output and the other resistor. You get the exact value and the nearest standard resistor, with the voltage it really gives.
  3. Add a load resistance to see how much a connected circuit pulls the output down.

Voltage divider formulas

Vout = Vin × R2 ÷ (R1 + R2) R1 = R2 × (Vin − Vout) ÷ Vout R2 = R1 × Vout ÷ (Vin − Vout)

With a load RL on the output, R2 is replaced by R2 ∥ RL = R2 × RL ÷ (R2 + RL). Example: to read a 0–20 V signal on a 3.3 V microcontroller pin, R1 = 51 kΩ and R2 = 10 kΩ give 20 × 10 ÷ 61 = 3.28 V at full scale.

For single resistors use the Ohm's law calculator.

Frequently asked questions

Two resistors in series across a voltage. The voltage between them is a fixed fraction of the input: Vout = Vin × R2 ÷ (R1 + R2). With 12 V in, R1 = 10 kΩ and R2 = 4.7 kΩ, Vout = 12 × 4.7 ÷ 14.7 = 3.84 V.

Pick R2, then R1 = R2 × (Vin − Vout) ÷ Vout. To get 3.3 V from 5 V with R2 = 10 kΩ, R1 = 10 × 1.7 ÷ 3.3 = 5.15 kΩ. The closest standard E24 value is 5.1 kΩ, giving 3.31 V. Use the “Find R1” tab and the calculator suggests standard values.

Usually not. A load draws current through R1 and pulls Vout down. Dividers work for high-impedance inputs such as a microcontroller's ADC pin or a transistor base, not for motors, LEDs or circuits that draw real current; use a voltage regulator instead. Enter a load resistance to see the effect.

Small values waste power; very large values make the output sensitive to noise and to any load. For signals into a microcontroller, 1 kΩ to 100 kΩ is typical. The calculator shows the current and the power each resistor dissipates.
Esc
↑ ↓ to moveEnter to open